Replacement Relay & Overload for SNAP Supply 61005518

Installation Instructions – Replacement Relay & Overload for SNAP Supply, LLC’s products 61005518

1. Unplug refrigerator to avoid electrocution
2. Remove refrigerator away from wall to allow access
3. Remove screws from access panel
4. Pull power cord up slot to avoid disconnecting it when removing access panel
5. Remove access panel and set aside
6. Remove wire harness located under relay assembly with needle nose pliers
7. Remove retaining clamp that hold assembly by pull up
8. Reach in and pull assembly out once the clamp has been removed
9. Remove relay by pulling on it
10. Set aside old relay
11. Take new SNAP Supply Relay & Overload out and install it
12. Make sure to aligning terminal with wire connectors
13. Place the retaining clamp back on by placing the small end into the slotted opening on top of the compressor
14. Lock the retaining clamp to the compressor
15. Reconnect the wire harness with pliers
16. Push it into place with hands
17. Reinstall back panel by dropping in power cord into in slot on the panel
18. Center the panel into place and replace the screws
19. Connect refrigerator