Replacement Dryer Element for SNAP Supply DC47-00019A

Installation Instructions – Replacement Dryer Element for SNAP Supply, LLC’s products DC47-00019A

1. Disconnect dryer to avoid electrocution
2. Remove the screws from the back of the dryer that secure the top panel
3. Slide panel back and remove top to set aside
4. Carefully remove the control panel from the top
5. Disconnect the wire harness and set panel aside
6. Remove screws on top securing the front panel
7. Open your dryer door and remove the two remaining mounting screws
8. Use flat nose screwdriver to unlock the locking tabs located on top
9. Pull the front panel forward
10. Disconnect the door switch panel & lift off
11. Set aside the panel
12. Disconnect the moisture sensor wires located at the bottom of the dryer
13. Remove the screws securing the heating element housing
14. Remove the housing from the bracket by pulling up
15. Remove the screws securing the bracket to the base
16. Take both the bracket and the heating element housing out
17. Note the wires and disconnect them
18. Using a screwdriver unscrew the high limit thermostat & thermal limit from housing
19. Remove screws securing the housing
20. With pliers pull the retaining tab up
21. Separate the housing
22. Use pliers to straighten the wire locking tabs and pull them out
23. Remove old dryer element and set aside
24. Take new SNAP Supply Dryer Element out and place it in the housing
25. Insert terminal wires in the locking tabs and bend them slightly to lock
26. Rejoin the two halves of the housing element by inserting the tabs into the slots
27. Use pliers to bend the inner tabs
28. Align the tabs with the housing using the screw holes & screw into place
29. Reposition the high limit thermostat and thermal limit to housing
30. Replace the screws
31. Connect the heating wires to the terminals
32. Return the housing to the dryer
33. Reposition the bracket by placing the slots into the base of the dryer
34. Secure using the screws
35. Reposition the heating housing by inserting the element into the bulkhead
36. Align the front tab to the bracket
37. Secure using screws
38. Reconnect the moisture sensor wires
39. Replace the front panel and connect wire to the door switch
40. Replace mounting screws
41. Reconnect the wire harness to the control panel
42. Align tabs on bottom and snap panel into place
43. Slide the top panel into place
44. Use screws to secure into place
45. Connect dryer outlet and begin using