Replacement Dryer Thermostat Kit for SNAP Supply 279973

Installation Instructions – Replacement Dryer Thermostat Kit for SNAP Supply, LLC’s 279973

1. Disconnect electrical power supply to the appliance
2. remove the access panel to on the bottom of the dryer
3. Remove wires from the high limit thermostat and thermostat cut off.
   1. To remember where the wires went use tape to mark them top or bottom
4. After wires have been disconnected, remove the 4 screws that hold the thermostats in place
5. Once you have them out, replace them with the kits thermostats.
6. Attach the wires to the new thermostats
7. Restore electrical power and test the dryer.