Replacement Dryer Gas Valve Coil Kit for SNAP Supply 279834
Installation Instructions – Replacement Dryer Gas Valve Coil Kit for SNAP Supply, LLC’s products 279834
Generic instructions based on common refrigerator models
- Disconnect electrical power supply to the appliance
- Lift up lint screen cover and remove screws.
- You need to release the hood by pressing in on the locking tab see images below
- Using a putty knife press in about 2 inches from the corner to hit the locking tab to release the top
- Release the door switch wiring harness
- Remove 2 screws holding front panel on
- Take front panel off by pull forward and up **wear gloves
- If your front panel is a 2 part, you need to release the bottom access panel
- Use a putty knife to pop it off
- Remove all the screws holding both panels and the door springs
- Remove the belt by releasing the idler puller by pulling it towards the outside of the dryer and releasing the belt Image below
- Now grab belt with one hand while supporting the drum with the other and pull the drum out the front of the dryer.
- To change out the coils, disconnect the terminals
- Remove the screws holding the coils in place
- Remove the bracket holding coils in place
- Remove coils
- *** Only on the large coil with 3 terminals, there will be a metal spacer that will be on the valve shaft make sure it did not come off with the coils
- put the new ones in place
- Screw the new coils in place
- Replace bracket and secure with screws
- Reconnect wire plugs
- Put drum back in same way you took it out. Gently place on roller wheels
- Spin the drum checking the felt on the drum did not slide out of place
- Put the idler pulley back into place by pushing the belt through the opening to create a loop that you can slide over the motor pulley see image bellow.
- Attach the front panel same way it came off
- Connect the door switch wiring harness
- Drop the hood into place over locking tabs
- Secure the hood by screwing the screws back into place through lint screen cover
- Turn your machine on and give it a try!
Leave a comment